Hondash

***This app is intended for use with Hondash Bluetooth scanner***

Hondash is the most capable monitoring tool and virtual dash for all Honda models with OBD1/2A/2B ECUs (1992-2001) that use the proprietary 3 pin or 5 pin DLC connector.

App features:

- real-time digital dash

- fuel statistics - instantaneous and average fuel consumption, total consumed fuel and

cost, fuel flow

- configurable multiple trip monitors for statistics such as fuel consumption, trip time, distance, VTEC engaged distance, top and average speed, etc.

- real-time parameter values:

vehicle speed, engine speed - revs, engine coolant temperature, intake air temperature, manifold absolute pressure, baro pressure, throttle position, battery voltage, oxygen sensor voltage, alternator FR, electrical load detector, exhaust gas recirculation EGR, short / long term fuel trim, injection duration, ignition advance, idle air control valve, knock, fuel system status, calculated load value, starter switch, A/C switch, A/C clutch relay, P/S oil pressure switch, brake switch, VTEC pressure switch, VTEC valve, VTEC indication lamp, A/T gear position, service check, fuel pump relay, oxygen sensor heater, oxygen sensor feedback loop status, EVAP purge control, malfunction indicator lamp, alternator control, radiator fan control, intake air bypass valve

- configurable parameter alarm triggers (engine temperature too high etc.)

- configurable on-screen graphs

- datalogging tool - continuous recording of all parameters for detailed analysis

- engine diagnostics tool - read and clear DTC fault codes

- calibration tools - higher accuracy of fuel consumption calculation, vehicle speed

car dynamics measurement tools - acceleration (0-100 kph, etc., 1/4 mile drag run), deceleration (100-0 kph, etc.)

- shift-light with audio-visual indication and individual gear shift point configuration

- daytime and nighttime color scheme

- support for metric and imperial units

In order to establish communication link with your car you need to use Hondash Bluetooth scanner, which can be purchased at http://www.hondash.net.

***此应用程序旨在与Hondash蓝牙扫描仪一起使用***

对于所有使用OBD1 / 2A / 2B ECU（1992-2001）使用专有3针或5针DLC连接器的本田车型，Hondash是功能最强大的监视工具和虚拟仪表板。

应用功能：

-实时数字破折号

-燃料统计-瞬时和平均燃料消耗，总消耗燃料和

成本，燃油流量

-可配置的多个行程监控器，用于统计数据，例如油耗，行程时间，距离，VTEC接合距离，最高和平均速度等。

-实时参数值：

车速，发动机转速-转数，发动机冷却液温度，进气温度，歧管绝对压力，气压，节气门位置，电池电压，氧气传感器电压，交流发电机FR，电子负载检测器，废气再循环EGR，短期/长期燃料调整，喷射持续时间，点火提前，怠速空气控制阀，爆震，燃油系统状态，计算的负载值，启动器开关，A / C开关，A / C离合器继电器，P / S油压开关，制动开关，VTEC压力开关，VTEC阀，VTEC指示灯，A / T档位，维修检查，燃油泵继电器，氧气传感器加热器，氧气传感器反馈回路状态，EVAP吹扫控制，故障指示灯，交流发电机控制，散热器风扇控制，进气旁通阀

-可配置的参数警报触发器（发动机温度过高等）

-可配置的屏幕图形

-数据记录工具-连续记录所有参数以进行详细分析

-发动机诊断工具-读取并清除DTC故障代码

-校准工具-燃油消耗计算，车速的准确性更高

汽车动力学测量工具-加速（0-100公里/小时等，1/4英里拖动运行），减速（100-0公里/小时等）

-带视听指示的换档灯和单独的换档点配置

-白天和晚上的配色方案

-支持公制和英制单位

为了与您的汽车建立通信链接，您需要使用Hondash蓝牙扫描仪，可以从http://www.hondash.net购买。